how hard is it to take the ZR2 Flair off and install them on a non-ZR2 ?

 

Theres a good amount of work involved. For the two door blazers i would imagine it would be a lot easier tho.

Theres a thread about it on here somewhere.

 

tried the search bar but doesnt come up with anything

need to know asap because someone has a parts truck and has the flairs on it and i want them :P

 

Here ya go bro... Clicky

This is the only diy guide for fender flares on here. Made by Wart. It's for a 4 door but the steps are similar. Plus you don't have to cut the rear one for the rear doors.

 

Thanks... suck it doesnt say how to remove them lol

 

True. Should be a heck of a lot easier than installing them lol. But Wart might have some advice for your situation if you get in touch with him.

 

They suck *** to remove...lol. Honestly its easier to swap the front fenders. Unless u wanna hack up your front fenders or the flares to make em work. Fenders are not identical between stock and zr2.

there bolted from the inside. theres plenty of access for the rear, you can feel your way around the opening. Front...they are basically inside the fender. Less u found the cleanest truck around...this will not be easy or remotely fun!!

 

double post

 

3inch ebay keys, ball joint flip, 2inch lift shackles, fullsize air shocks with onboard compressor aditional 1-3inches of lift, zone 2inch body lift, 1997 pontiac firebird 16inch rims, and 265/75/16 (32.2inch tire) treadwright guard dog M/T's

 

Trucks look sick bud !

Thanks Skotti !