Engine problem
#31
09-17-2018, 11:09 AM
Good Morning Everyone. Just waiting on my brother to call sense he owns the machine shop. Him and i was talking over the weekend. Thinking about dropping a Diesel engine in it. custom Building.If i do that i am going to go manual transmission. It can be done between his shop and mine. But a lot of time and work and money. i do have a 2001 Dodge Dakota converted in a stranded Trans with a Cummins Diesel along with my rollback. But if i go with a diesel motor i would like to stick with a Chevy Engine the new Colorado has a 2.8 liter Duramax Turbo diesel. We can custom build to fit.
Last edited by LesMyer; 09-17-2018 at 11:12 AM.
#32
09-20-2018, 11:09 AM
It does sound like you may be better served at a forum that discusses custom engine builds/installations. I think our sweet spot here is helping DIY'ers understand their specific failures and guide them to repair them and get their daily driver back on the road.
Good luck with your project.
George
Good luck with your project.
George
#33
09-20-2018, 02:03 PM
Cannot resist not to bring an old sentence on the art of diplomacy here. "It is to tell someone to .... so that he can feel the joy of approaching journey" LOL.
By the way, I've been to one workshop today to machine my other car brake drum. I asked about my old engine and they could make me a custom crank shaft bearing. So, even if shaft does not apply for stock over sized bearings, still may be fixed.
By the way, I've been to one workshop today to machine my other car brake drum. I asked about my old engine and they could make me a custom crank shaft bearing. So, even if shaft does not apply for stock over sized bearings, still may be fixed.
#34
10-10-2018, 05:53 PM
I stuck with the stock engine. I have way too much money tied up into it. Fired it up for the first time runs good. I only have 2 problems I'm throwing a 1345 I am guessing my timing is off. Now on the 2000 blazers can you adjust the timing. The other problem that i am having is the Fuel gauge is not working.
Thank you so much LesMyer ,Mike And George for all of your help.With Engine.
Thank you so much LesMyer ,Mike And George for all of your help.With Engine.
Last edited by tommyboy8072002; 10-12-2018 at 05:39 PM.
#35
10-12-2018, 09:54 AM
LesMyer Yes i did need help sorry i wasn't trying to start anything. Thank you for your help i shouldn't of said what i said. i had the heads all redone. I am guessing the valve guides. is what caused the problem. Any who i think i might of Pinched a wire somewhere or something my fuel gauge quite working. Not too sure where to look. I am hoping someone on here can help me with that.. I am truly sorry. And thank you for everything
#36
10-12-2018, 11:31 AM
Fuel gauge Problem
HI everyone. Long story short. I pulled the Engine and put it back in. Fuel gauge now doesn't work. Was working fine Before i pulled the engine. Not sure if i pinched the wire or even where to look. all my other gauges work fine.
Thread
Thread Starter
Forum
Replies
Last Post
davidsv8mustang
2nd Generation S-series (1995-2005) Tech
1
02-18-2010 02:29 PM
vernzr2
2nd Generation S-series (1995-2005) Tech
8
03-15-2008 08:10 PM