2000 Chevy Blazer 4x4 no fire
#21
i am having a similar problem with my 2000 blazer 4.3 vortec, blew intake gasket, replaced intake and head gaskets, now now fire, i have power to one wire that goes into the coil, but not the other side, replaced ignition moduel, coil pack, new plugs and wires, any ideas, i have put alot of money into it this past year and would love to be able to enjoy it, thank you
#22
Check fuzes and recheck the wiring to the ICM and coil.
Did you replace the electrical connector on the backside of the distributor? I almost forgot this when I replaced the intake gaskets.
Perhaps you have broken a wire due to all the moving around required to replace the intake gaskets.
You will probably have to begin checking continunity between the wires going to the coil/ICM which will require a good wiring diagarm.
Good luck.
Did you replace the electrical connector on the backside of the distributor? I almost forgot this when I replaced the intake gaskets.
Perhaps you have broken a wire due to all the moving around required to replace the intake gaskets.
You will probably have to begin checking continunity between the wires going to the coil/ICM which will require a good wiring diagarm.
Good luck.
Last edited by LannyL81; 01-11-2013 at 08:43 AM.
Thread
Thread Starter
Forum
Replies
Last Post
huntinglonewolf
1st Generation S-series (1983-1994) Tech
4
06-24-2011 07:03 PM
Bad Attitude
2nd Generation S-series (1995-2005) Tech
10
12-08-2009 03:00 PM