AFT in Vaccum canister
#1
AFT in Vaccum canister
Happy New Year,
I have 95 blazer 4x4 4.3 and have trouble with engaging 4 w drive. I hear a shifting noise below but it does not actually do anything. I have been searching out vaccum lines and found AFT inside my canister attached to the hood. Does any one know whats up with this and could this be associated with my 4 w drive issue?
Thanks in advance
I have 95 blazer 4x4 4.3 and have trouble with engaging 4 w drive. I hear a shifting noise below but it does not actually do anything. I have been searching out vaccum lines and found AFT inside my canister attached to the hood. Does any one know whats up with this and could this be associated with my 4 w drive issue?
Thanks in advance
#2
RE: AFT in Vaccum canister
The t-case uses ATF as the lubricant.
The front axle engages by vacuum from teh t-case.
Follow the vacuum hoses of the t-case. Should be 3 of them attached to the top of the t-case and run to various places. Make sure your t-case is full as well. Should be a fill hole on the back side of it.
The front axle engages by vacuum from teh t-case.
Follow the vacuum hoses of the t-case. Should be 3 of them attached to the top of the t-case and run to various places. Make sure your t-case is full as well. Should be a fill hole on the back side of it.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff229
2nd Generation S-series (1995-2005) Tech
17
11-11-2010 01:25 PM
Jeru
2nd Generation S-series (1995-2005) Tech
1
10-20-2009 08:09 PM