Harness ID & Pinning
#1
11-05-2010 | 12:29 PM
Thread Starter
|
Beginning Member
Joined: Aug 2010
Posts: 15
Harness ID & Pinning
Hi all.
i am in need of some help...
i have the drive train of a 2002 blazer in my jeep. i am having a few problems that i cant quite figure out. most of them are electrical and i *think* i have got it narrowed down. so to the question:
the pics below are of the wire harness directly out of the PCM. i have a diagram that i thought was from a 2002 manual but does not fit with the actual plugs. if i could get a conformation on what the plugs are, and the big issue, possibly a pinout for the 16 pin plug it would be MUCH appreciated.
i am in need of some help...
i have the drive train of a 2002 blazer in my jeep. i am having a few problems that i cant quite figure out. most of them are electrical and i *think* i have got it narrowed down. so to the question:
the pics below are of the wire harness directly out of the PCM. i have a diagram that i thought was from a 2002 manual but does not fit with the actual plugs. if i could get a conformation on what the plugs are, and the big issue, possibly a pinout for the 16 pin plug it would be MUCH appreciated.
#2
11-05-2010 | 12:41 PM
Thread Starter
|
Beginning Member
Joined: Aug 2010
Posts: 15
ok, i guess that sense i am asking, i should ask what the circled plug goes to also...
#3
11-07-2010 | 02:04 PM
Thread Starter
|
Beginning Member
Joined: Aug 2010
Posts: 15
Nothing at all?
#5
11-09-2010 | 06:27 PM
Speed sensors for the transfer case?
Thread
Thread Starter
Forum
Replies
Last Post
JohnBarJB
Audio/Video Electronics
17
09-28-2020 07:34 PM
dj00140
2nd Generation S-series (1995-2005) Tech
2
04-13-2011 10:40 AM
dougs10
Steering, Suspension & Drivetrain
1
12-14-2010 03:24 PM
bfsmith72549
2nd Generation S-series (1995-2005) Tech
3
11-01-2010 05:44 PM