locking rear end in a 2wd
#1
locking rear end in a 2wd
here is my basic question. why does every locker on Summit Racing and other sites show that they only fit in 4wd trucks? i'm looking to get one for my truck because my rear end is getting rebuilt (again) and i figure while they're at it, i might as well.
nevermind..... i just made myself a hypocrit... i searched
https://blazerforum.com/forum/showth...g+differential
nevermind..... i just made myself a hypocrit... i searched
https://blazerforum.com/forum/showth...g+differential
Last edited by MTopper; 11-10-2010 at 11:48 PM.
#2
Hey, that's one of my old threads.
Yeah, I think I've set myself to getting a lock-rite rear locker.
Yeah, I think I've set myself to getting a lock-rite rear locker.
#3
If you have an 8.5" ring gear, buy my locker... Holy **** they are freakin awesome... You should see the crap ive been going through with only 2wd.
#4
i have the smaller rear axle. i did figure out i have 3.42 gearing though. Matt, i figured you'd see this sooner or later because of that thread.
my only problem is that the only locker that "fits" in an 04 according to most sites is a detroit locker from Eaton and then it only fits in the 4wd. i call bs and am going to call them tomorrow
my only problem is that the only locker that "fits" in an 04 according to most sites is a detroit locker from Eaton and then it only fits in the 4wd. i call bs and am going to call them tomorrow
Thread
Thread Starter
Forum
Replies
Last Post
SOB1999JIMMY
Steering, Suspension & Drivetrain
9
03-13-2023 04:30 PM
Fossil Rock
Steering, Suspension & Drivetrain
0
09-21-2012 01:48 PM
brino1
Steering, Suspension & Drivetrain
5
02-25-2011 08:05 PM