Power Wire
push it through from the inside about a foot or so and then go around to the engine and reach down b/w the ac and pass. side exhaust manifold and feel around for it... also, in the pass side wheel well, there is a flap that you can lift up and you should be able to see the wire looking through the flap
ORIGINAL: hillbillyinOhio
just so you know, I had three runs of 1/0 through that grommet.
just so you know, I had three runs of 1/0 through that grommet.
Mines basically the same way as jagblazers only drilled up through to that trap door in the xtremes by the rear seats. then run up through my panel to the back.
ORIGINAL: XBlazer01
Mines basically the same way as jagblazers only drilled up through to that trap door in the xtremes by the rear seats. then run up through my panel to the back.
Mines basically the same way as jagblazers only drilled up through to that trap door in the xtremes by the rear seats. then run up through my panel to the back.
Thread
Thread Starter
Forum
Replies
Last Post
chris015
1st Generation S-series (1983-1994) Tech
2
Jul 8, 2012 01:19 AM
bubba181x1
Full Size K5 (1969-1991) GMT415 (1992-1994) Tech
3
Mar 12, 2008 02:05 AM







