Audio/Video Electronics Wired up? If you have some sort of A/V modification let's hear about it here. Discussion of stock electrical problems should be done in the 'Lighting & Electrical' section.

power wire

Old Feb 22, 2007 | 08:15 PM
  #1  
blazerlove9196's Avatar
Thread Starter
Joined: Feb 2007
Posts: 12
From:
blazerlove9196 is an unknown quantity at this point
Default power wire

where would be the best place to run my power wire for my amp? i was thinking about running in toward the back from the battery, accross to the driver's side, then through the firewall there. Is this the best place to put it? Where has everyone else been running their power wire?
 
Old Feb 22, 2007 | 08:25 PM
  #2  
hillbillyinOhio's Avatar
Administrator
Joined: Nov 2005
Posts: 2,931
From: Zanesville oHIo
hillbillyinOhio has disabled reputation
Default RE: power wire

would be really helpful if we knew what year your truck was. On 2nd Gens, there is a grommet on pass side between feet, under the carpet. Antenna wire comes through the same grommet, then run it down the pass side. on drivers side, if its a small gauge wire, you can prob squeeze it through the hood pull grommet.

On first Gens, there is an antenna grommet on same side, but a lil higher in the dash.
 
Old Feb 22, 2007 | 08:28 PM
  #3  
TheBrettster's Avatar
Super Member
Joined: Jul 2006
Posts: 1,255
TheBrettster has a reputation beyond reputeTheBrettster has a reputation beyond reputeTheBrettster has a reputation beyond reputeTheBrettster has a reputation beyond reputeTheBrettster has a reputation beyond reputeTheBrettster has a reputation beyond reputeTheBrettster has a reputation beyond reputeTheBrettster has a reputation beyond reputeTheBrettster has a reputation beyond reputeTheBrettster has a reputation beyond reputeTheBrettster has a reputation beyond repute
Default RE: power wire

I did the same thing, I just made a hole right above the back of the wall right beside wheel well then under the carpet. On my 4door.
 
Old Feb 22, 2007 | 11:09 PM
  #4  
blazerlove9196's Avatar
Thread Starter
Joined: Feb 2007
Posts: 12
From:
blazerlove9196 is an unknown quantity at this point
Default RE: power wire

i have the wire ran for my 91, but it was there when i bought it so i'm not sure where that one was ran. I'm seeing where i can put it on my 96-when i bought it they had it ran on the inside of the fendor, down the door hinge and under the door trim....not a good place for the power wire but it seems like it is hard to get to everything else....i'll take a look at the suggestions when it is light out
 
Old Feb 22, 2007 | 11:14 PM
  #5  
hillbillyinOhio's Avatar
Administrator
Joined: Nov 2005
Posts: 2,931
From: Zanesville oHIo
hillbillyinOhio has disabled reputation
Default RE: power wire

DO NOT, I REPEAT, DO NOT run power wire through fender and down the door hinge. if that wire moves and gets pinced, then things start to smoke. pull back the carpet on the pass side about a foot, you will see the large grommet about where your left foot would be if you were sitting in the seat. RUN through there.


I also donot suggest running wire on the outside of your car. Too many ways to get it snagged on something, and rubbing on metal.
 
Old Feb 23, 2007 | 12:45 AM
  #6  
blazerlove9196's Avatar
Thread Starter
Joined: Feb 2007
Posts: 12
From:
blazerlove9196 is an unknown quantity at this point
Default RE: power wire

yes i know this hillbilly about not running it thru the fender and down the door, or outside of the vehicle...that is how it was when i bought it, and the first thing to get ripped out
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
chris015
1st Generation S-series (1983-1994) Tech
2
Jul 8, 2012 01:19 AM
DJ 4x4
Lighting & Electrical
0
Sep 26, 2011 09:44 PM
bubba181x1
Full Size K5 (1969-1991) GMT415 (1992-1994) Tech
3
Mar 12, 2008 02:05 AM
alpinejimmy
Audio/Video Electronics
11
Jan 20, 2006 09:38 AM
massaudio
Audio/Video Electronics
2
Nov 17, 2004 11:22 AM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 11:37 PM.