Engine & Internal Chat about beefing up your Blazer's engine insides here.

belt noise

Old Aug 25, 2006 | 10:47 PM
  #1  
blazerfanatic's Avatar
Thread Starter
Joined: Aug 2006
Posts: 2
blazerfanatic is an unknown quantity at this point
Default belt noise

Hello I have a belt noise that occurs only when the engine is cold or with a/c off. The vehicle is a '97 Blazer 4.3. Any help would be greatly appreciated. Thanks!!!!
 
Old Aug 25, 2006 | 10:54 PM
  #2  
swartlkk's Avatar
Administrator
Joined: May 2005
Posts: 41,331
From: Waterloo, NY
swartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond repute
Default RE: belt noise

So does it do it when the engine is cold and the a/c is off...? Or will it squeal when the engine is cold and the a/c is on as well?
 
Old Aug 27, 2006 | 06:17 PM
  #3  
blazerfanatic's Avatar
Thread Starter
Joined: Aug 2006
Posts: 2
blazerfanatic is an unknown quantity at this point
Default RE: belt noise

It is only when it is cold and the a/c is off. It goes away if u turn the a/c on.
 
Old Aug 27, 2006 | 09:21 PM
  #4  
swartlkk's Avatar
Administrator
Joined: May 2005
Posts: 41,331
From: Waterloo, NY
swartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond reputeswartlkk has a reputation beyond repute
Default RE: belt noise

K. I couldn't tell from your original description of the problem. Sounds like you have a problem with the clearance on the A/C compressor clutch. This could be caused by rust in the clutch plates. I believe that there is a bolt that holds the compressor drive on the end of the compressor, then the pulley itself is held on with a snap ring (IIRC).
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
lionel2
2nd Generation S-series (1995-2005) Tech
3
Sep 7, 2012 02:45 PM
thecoutures
Engine & Transmission
3
Apr 13, 2007 01:24 AM
MsRandi
General Tech Help
2
Jul 7, 2006 09:19 AM
curly2001
2nd Generation S-series (1995-2005) Tech
11
Jun 4, 2005 07:42 PM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 03:56 PM.