rusted tansmission lines 1994 s10 4wd, 4 dr. 4.3 w
#1
![Default](https://blazerforum.com/forum/images/icons/icon1.gif)
![Icon Hyper](https://blazerforum.com/forum/images/smilies/icon_hyper.gif)
Last edited by fslobodecki@yahoo.com; 04-12-2011 at 02:56 PM. Reason: forgot to add more info.
#2
![Default](https://blazerforum.com/forum/images/icons/icon1.gif)
well, i found out that these lines are 5/16 od. steel. i can get some 5/16 od lines from the auto parts store ,and some unions and piece them out. i was going to use trans. rubber lines, but the exhaust pipe is too close and may cook the rubber and then split open.
#3
![Default](https://blazerforum.com/forum/images/icons/icon1.gif)
you can buy prefabbed lines from napa pretty cheap . they even come with the retaining clips. way easier than makin them.
Thread
Thread Starter
Forum
Replies
Last Post
94driven
Engine & Transmission
6
02-13-2015 07:19 PM
fslobodecki@yahoo.com
Engine & Transmission
4
04-15-2011 03:29 PM
blazersince87
2nd Generation S-series (1995-2005) Tech
2
03-24-2011 05:32 PM
ComputerNerdBD
2nd Generation S-series (1995-2005) Tech
17
08-07-2010 06:00 PM