what have you gotten done on your blazer today?
lmao I just thought the same thing as I was scrolling
That is one CLEAN interior. Makes me want to wash and detail mine this weekend...
Maybe...
That is one CLEAN interior. Makes me want to wash and detail mine this weekend...
Maybe...
But I was really liking the wood grain dash bezel and passenger vent.
My want list is endless.
Got the front end aligned after having to replace the upper ball joints in the Rough Country upper control arms. The ones that came with the control arms did not have Zerk fittings. When doing the work necessary to replace the front left output shaft seal I noticed the one upper ball joint was bad. I decided to change out both of them. Being the press-in type I learned how to use a new tool.
The down side is some how I messed up one of the ABS sensors. It is probably the one on the left side. When first installed the upper control arms, I routed the ABS sensor wire in a way that ended up rubbing off the insulation. I'm hoping it is just that simple. Don't you hate it when you think you have fixed one thing, another pops-up? LOL
The down side is some how I messed up one of the ABS sensors. It is probably the one on the left side. When first installed the upper control arms, I routed the ABS sensor wire in a way that ended up rubbing off the insulation. I'm hoping it is just that simple. Don't you hate it when you think you have fixed one thing, another pops-up? LOL
Got the front end aligned after having to replace the upper ball joints in the Rough Country upper control arms. The ones that came with the control arms did not have Zerk fittings. When doing the work necessary to replace the front left output shaft seal I noticed the one upper ball joint was bad. I decided to change out both of them. Being the press-in type I learned how to use a new tool.
The down side is some how I messed up one of the ABS sensors. It is probably the one on the left side. When first installed the upper control arms, I routed the ABS sensor wire in a way that ended up rubbing off the insulation. I'm hoping it is just that simple. Don't you hate it when you think you have fixed one thing, another pops-up? LOL
The down side is some how I messed up one of the ABS sensors. It is probably the one on the left side. When first installed the upper control arms, I routed the ABS sensor wire in a way that ended up rubbing off the insulation. I'm hoping it is just that simple. Don't you hate it when you think you have fixed one thing, another pops-up? LOL
You may wish she stays out of town when she figures out where the spray paint overcast and paint smell in the house came from LOL. But years ago when I was married I had been known to rebuild carbs at the kitchen table
I'm obviously a bit of a motor-head so yeah, bring them inside to drive BUT not in the living-room!!! LOL