Actually, now that you mention it, I may just go with amber LED's in all 4 of the 3157 (2 per side) locations. The turnback's wouldn't do anything in the DRL position because that is the inside most bulb and only uses one filament.

*EDIT* Well crap... The SuperbrightLED.com 18 led tower style 3157 replacement states not to use in GM DRL...

 

Well there ya go. Will look good with the silverstars for sure!

 

Kyle... are DRL's required in your state? If not I suggest turning your DRL's into signals...

http://www.gmfullsize.com/forum/show...king+light+mod

 

I probably wouldn't get hassled if I were to get rid of them.

One thing that I'd really like to do is convert the whole front end over to the Silverado front end! (waits for dad to get rear ended with his '04 2500HD so I can take the front end and LQ4)

 

Haha I personally like the front ends but it depends on the silvy donor. 2004-2007 Might as well start tearing it apart now lol

It would be alot of work tho! basically the whole front clip needs to be changed.

 

I think it's just fenders, hood, and then the grill stuff. I think the core supports are the same. Not that it would be too much more work to swap that over! LOL

But yeah, it's an '04 2500HD as I said. I'll have to get a picture of the two of them side by side.

 

Yea true! Worse comes to worse go grab a 02 diesel hood. I like the higher rise on it!

 

this

plus this

equals new ball joints and hubs. what a pita.

 

Posted a new build thread with pictures of the new turn signal lenses.

 

took the jimmy for an E-Test - FAILURE for too high HC ppm, CO%, and NO ppm... pretty sure i'm just gonna say fukkit and sell this thing before it chews into my pocket book too much further.

edit: gonna check into the pricing on a new cat for it since that seems to be the commonality in all of the failures for it and my mech buddy said that is a for sure replace on the list to pass