what have you gotten done on your blazer today?
#2811
![Default](https://blazerforum.com/forum/images/icons/icon1.gif)
wait4me performance PCM came today. Threw it in and immediately noticed a smoother idle. After 2.5 minutes evap, o2 heater, o2 and secondary air cleared. egr and cat cleared after a mile. BIG improvement in shift performance. I don't know if I gained any power (probably not) but the shift improvement is phenomenal. 1-2 shift it spins the tires and it's a nice firm direct shift from 2-3.
#2814
![Default](https://blazerforum.com/forum/images/icons/icon1.gif)
Wet and muddy out and wanted to go play. So I killed 2 birds with one stone and went to the junk yard lol. Picked up my spare tire swing for the back, front bumper and got a full sized aluminum rim to match the ones on the truck (for the spare on the tailgate) all for $140 bucks. All of it looks really nice, no reconditioning needed. Now I hope I didnt pick up any trash in my tires mud runnin in a junk yard.
#2815
![Default](https://blazerforum.com/forum/images/icons/icon1.gif)
Attempted to fix the passenger side door. Wont open from the outside. found the pin came undone so I tried putting it back in place... 2 hours later I finally got it... damn these large arms... when I went to test it the door opened halfway and it popped out again... I gave up, lol.
#2817
![Default](https://blazerforum.com/forum/images/icons/icon1.gif)
You could go ahead and replace the cap and rotor. Just remember not to over torque the screws. ![Smile](https://blazerforum.com/forum/images/smilies/smile.gif)
New Rough Country Upper Control Arms installed and got an alignment today. Rides much much better now. I took off my chrome wheel well guards and plan to paint the chrome on the door guards and rear quarter panels black tomorrow.
![Smile](https://blazerforum.com/forum/images/smilies/smile.gif)
New Rough Country Upper Control Arms installed and got an alignment today. Rides much much better now. I took off my chrome wheel well guards and plan to paint the chrome on the door guards and rear quarter panels black tomorrow.
#2819
![Default](https://blazerforum.com/forum/images/icons/icon1.gif)
i intend to do the same thing ^^^^ cept i know the yard i go to has half a dozen blazers/jimmys with the rear disc setups in them.
wednesday night - installed new u joints on the main drive shaft - old ones would stick in the middle @ 0deg of rotation
also installed transfer case vac switch thinking it'd fix 4x4 - no dice, also updated my 4x4 thread but no one has even posted to it or anything - Boo urnz
wednesday night - installed new u joints on the main drive shaft - old ones would stick in the middle @ 0deg of rotation
also installed transfer case vac switch thinking it'd fix 4x4 - no dice, also updated my 4x4 thread but no one has even posted to it or anything - Boo urnz