what have you gotten done on your blazer today?
#4691
But if you win the lottery, Check these guys out. 300W thrown to one of these guys subs (in spec of course their higher end stuff wants more lower end wants less) will pound just as hard as 2 12"s with 1200W to them. The cones are actually woven carbon fiber.
CDT Audio Car Audio and Upstage Sound
Gettin her ready to go off roading today
CDT Audio Car Audio and Upstage Sound
Gettin her ready to go off roading today
But the hd speaker component package is $599.99?
Whew! Even with the lottery, I'd have to think about that high of a price!
#4692
swapped my starter out took me about an hour but i didnt get to put my skid plate back on since i went out and came home late
I also installed the center console door i got from the pick and pull its great not to have it floating around any more
and i just finished soldering the defrost wire extension as i wrote this post
I also installed the center console door i got from the pick and pull its great not to have it floating around any more
and i just finished soldering the defrost wire extension as i wrote this post
Last edited by xgiovannix12; 12-04-2011 at 04:54 PM.
#4693
soldered my rear defrost back together. and fixxed my rear squirter. found out that the guy before me sat there and held it and drenched the back of the blazer in the fluid.
also did a full detail on it.
also did a full detail on it.
#4694
#4696
first time driving after replacing the hub/bearings up front. No more ABS problem! runs noticibly quieter/smoother too!
Got the lift shackles on the rear end to level it out with the zr2 tbars up front. Eventually I may put bigger tires on.
Once it gets a bath, I'll post pics
next project....what the *$%& is that rattling noise in the drivers side door?
Got the lift shackles on the rear end to level it out with the zr2 tbars up front. Eventually I may put bigger tires on.
Once it gets a bath, I'll post pics
next project....what the *$%& is that rattling noise in the drivers side door?
#4697
Beginning Member
Join Date: Dec 2011
Posts: 24

I cleaned the air mass sensor and throttle body. I bought a couple of cans of the CRC products. Seemed to work pretty good. Both were dirty. I am still trying to get my rear wiper to work. I bought a few rebuilt motors. They work for a day or two then it craps out. Also need to replace the O2 sensor bank 1. Anyone with any information, pictures and/ or videos would be greatly appreciated. I mean for the rear wiper or O2 sensor I need to replace. Thanks Bernie11
#4698
Not done today, but the last couple months: Got a set of 4 Kumho Road Venture SAT KL61 tires installed on the blazer. Installed 2 Valvoline Aquablade wiper blades, swapped out brake lights for LED bulbs, swapped back up light for a brighter bulb, and replaced oe taillight lenses with some cheap ones I found somewhere online.








