flowmaster question?
#11
09-04-2007, 01:24 AM
RE: flowmaster question?
ORIGINAL: DetroitMuscle
Most shops have a $40 rack fee, the weld if the shops hold the same rules there only costed you $10.
I wouldnt put a flowmaster let alone a 40 series on a stock engine...especially with a cat on it.
ORIGINAL: Taymacjack
yeah that would work out fine. you just have to make sure that the inlet and outlet of the flowmaster is in the right place for a blazer. While your at it, you might want to think about a cat back exhaust. I only paid 50 bucks to have them weld in my flowmaster (kind of a rip off for one weld i guess), but i cant imagine that it would cost much more than that.
yeah that would work out fine. you just have to make sure that the inlet and outlet of the flowmaster is in the right place for a blazer. While your at it, you might want to think about a cat back exhaust. I only paid 50 bucks to have them weld in my flowmaster (kind of a rip off for one weld i guess), but i cant imagine that it would cost much more than that.
Most shops have a $40 rack fee, the weld if the shops hold the same rules there only costed you $10.
I wouldnt put a flowmaster let alone a 40 series on a stock engine...especially with a cat on it.
Thread
Thread Starter
Forum
Replies
Last Post
okstud
Headers, Intake, & Exhaust
14
02-14-2010 09:21 PM
new03blazer
Headers, Intake, & Exhaust
4
11-02-2006 09:43 PM
