I will see if a blazer grill will fit on the bumper before I do anything.

 

Truck started to overheat on a 15 min drive, so I had to go and get a rad today. 50$ from the upull... grabbed a tensioner pulley while I was there... so far so go, rad was basicly new out of an s10.

gonna do a flush and oil change once I get back for the nascar race this weekend.


^^^^old^^^^

^^^^ new to me^^^^

 

Had the stabalizer link bracket on the control arm break off... had to remove the sway bar for now... also scored another Camaro rim, so swapped out my spare. Now I got a set of 5 matching rims for both summers and winters...

 

Woooo, that matching spare rim looks sweet! That is exactly the reason I also bought 5 of those Camaro rims.

 

I've always loved them. It all started with the Camaro z28s. I cant wait for the end of next season, I get to start looking for bigger tires 😁😁.

 

Went to the u pull today. Was looking for a control arm, came out without one. But I got flares and aluminum skid plates, for less then 100$. Ran into a fellow blazer owner, sounded like he had a 2door r
zr2. He grabbed a centerlink, and an air box for a snorkel project.

 

 

Found carbon fiber last time, did not have time to pull them tho. Was lucky and found these on a 96. Flares came off a 02 jimmy zr2.

 

Nice haul! I got a full set of carbon fiber skids. I tried to put the oil pan cover on and realized my blazer didn't have the rear connection pieces for it. Made another trip and got them.
I always check out the flares, but most are too rusty to remove. Looking forward to seeing I how you customize them to fit the back.
​​​​​​

 

Did some work on the fender flares. Got the front driver side mocked and trimmed... now to figure out brackets, and thinking about a little spray foam behind them to add some double sided tape above the lip.
Stock flare mounts and side lip

Trimmed


Mocked into position.

I'm like a kid a Christmas... so excited lol.