My new exhuast
#11
That sounds fantastic. Well done.
#12
Very very nice, I also have an extreme and want duals, thanks for the idea on how to get it done.
#13
I have reg bulbs & LED reverse lights ALA Jonathan (Streblo) & mine have been ok so far - knock on wood.
Tips look great, welding looks uhhhh bubbly lol (sorry man, been a welder for 17 years). It's a bit louder than I like & I have a single in/dual out straight through muffler with the pre cat removed & it's loud but not too loud.
Funny thing is when I rev & let go of the throttle fast like you did in the vid, my blazer drops below 600rpm & stutters too lol
Very nice job especially for a freebie & now DUALS!!!
Last edited by Rottidog; 12-01-2011 at 10:24 PM.
#14
I have the same tail lights & YES the tabs are SH*#! Just tightening up the top screws broke both tabs. Thank God the lights have that bolt going through in behind the light housing to keep it from flopping around.
I have reg bulbs & LED reverse lights ALA Jonathan (Streblo) & mine have been ok so far - knock on wood.
Tips look great, welding looks uhhhh bubbly lol (sorry man, been a welder for 17 years). It's a bit louder than I like & I have a single in/dual out straight through muffler with the pre cat removed & it's loud but not too loud.
Funny thing is when I rev & let go of the throttle fast like you did in the vid, my blazer drops below 600rpm & stutters too lol
Very nice job especially for a freebie & now DUALS!!!
I have reg bulbs & LED reverse lights ALA Jonathan (Streblo) & mine have been ok so far - knock on wood.
Tips look great, welding looks uhhhh bubbly lol (sorry man, been a welder for 17 years). It's a bit louder than I like & I have a single in/dual out straight through muffler with the pre cat removed & it's loud but not too loud.
Funny thing is when I rev & let go of the throttle fast like you did in the vid, my blazer drops below 600rpm & stutters too lol
Very nice job especially for a freebie & now DUALS!!!
Its hard to beleive that im ASE/I car certified to weld on structural parts to cars lol. Real soon I want to spend some cash ad get a real nice miller wender but for now this one works.
Thread
Thread Starter
Forum
Replies
Last Post
aberabee
1st Generation S-series (1983-1994) Tech
5
04-27-2009 10:05 PM
k5purplehornies
Full Size K5 (1969-1991) GMT415 (1992-1994) Tech
3
02-22-2009 03:03 AM