I lifted the wiper blades off the windshield before the snow fell today. Other than that, I put gas in about a week or so ago.

 

Put a Flowmaster Super 44 on the Ford and did a tune up on the colorado this week.

 

After a much needed oil change...

I've been looking at this for a wile... after rubbing with my old 31's my lower valance was cracked on the passenger side... got tired of seeing it flop around today and "ripped" it off... proceeded to trim up the rest with a sharp knife and make the driver's side match

Doesn't look great, but doesn't look terrible. Better than plastic flopping in the wind...

 

Got the other 2 tires today. And as a way of saying thank you, it refused to start for about 15 minutes in the driveway. Ungrateful bitch.

 

Right turn blinker started blinking fast so I picked up new bulbs and changed out the rears first. Works good now.

 

I laughed way more then i should have at this LOL sorry.

 

Getting ready to putting on a level kit on my 04. it's 2 inches on rear and 3 inches on front. Not sure if 20 in wheels will work or not. If not going with 17 in

 

Hi

I have pretty much stripped the old bumper need to do some more . I crawled up under it yesterday and there is no way in all that is holy the old bumper is coming off it is far to rusted on to get it off without cutting it off and if i do that the new one is not going back on sooooooooooooooo time to get creative with help from the wizards of youtube *lol* . I know that it is just putting "lipstick on a pig" but if there was any other way..

I will keep you posted on ho it goes

Regards

 

Wire brush the threads cleaning them up. get mapp gas torch or aceteline iff you can. Heat up the nut red hot, breaker bar or some type of extension on your wrench or socket. It will come off

 

Cut 2 holes in my frame the other day