what have you gotten done on your blazer today?
#1954
So I'm lining everything up on my engine right now... and neither my Dad's Headers or my Exhaust Manifold fit onto my Heads... they are both just a tad bit off.
On a side note... posting up more pictures in my build thread.
On a side note... posting up more pictures in my build thread.
Last edited by ChevyBlazerChick; 09-24-2010 at 11:42 PM.
#1955
I installed my $12 "gravel shield" from the pick and pull; my oil pan will now be safe from all sorts of flying pebbles and whatever else i may ram it into.
Trimmed the back bottom corner's of my fenders to make a little more room for my new tires (31's) I think it looks better this way too, more natural with the larger tires. i'm just concerned about the new sharp edges slicing my tire if they do rub by some very likely chance (since i don't have a lift and all)
Installed the tranny temp gauge i've had sitting in my door since last feb when i did the tranmission. I ripped the cassette deck out since it didn't work with my after market deck anyways and plopped 'er in there instead. i had to file it out abit but it looks pretty good, blends away really nicely other than the gaping hole next to it. I even got the dash dimmer wired in there and everything... oooo
hopefully tomorrow i'll actually wash my truck
Trimmed the back bottom corner's of my fenders to make a little more room for my new tires (31's) I think it looks better this way too, more natural with the larger tires. i'm just concerned about the new sharp edges slicing my tire if they do rub by some very likely chance (since i don't have a lift and all)
Installed the tranny temp gauge i've had sitting in my door since last feb when i did the tranmission. I ripped the cassette deck out since it didn't work with my after market deck anyways and plopped 'er in there instead. i had to file it out abit but it looks pretty good, blends away really nicely other than the gaping hole next to it. I even got the dash dimmer wired in there and everything... oooo
hopefully tomorrow i'll actually wash my truck
#1956
Cruise control box started grinding the other day so I disconnected both speedometer cables. Today I completely removed the cruise control and installed a new speedometer cable. I also tore apart the dash and gauge cluster trying to fix the gas gauge.
#1957
Well flushed brake system completely! Man that brake fluid hasn't been flushed since the truck was bought. Green rusty looking fluid FTL! Dern them copper! Took me forever to bleed the air out after flushing it. used a big thing of brake fluid. Had some red engine paint and had fun...also changed my serp. belt. Also courtesy of firestone crossthreading one of my lug nuts...had to replace a wheel stud.
yes....I still have yet to finish getting all the mud off....
yes....I still have yet to finish getting all the mud off....
#1959
I went and replaced my radiator. Bought new oil line quick disconnects. And all my fluid leaks have stopped. The radiator has been leaking for about 2 months. Oil lines where they connect to the radiator have been leaking for years. So after 4 hours, I presently have no leaking. Now for the not so funny thing. It seems like every time I fix something on my Blazer I end up braking or close to braking something. Well I noticed that my ac compressor was leaking where the lines connect on top. Well like a dumb a** I put a wrench on it. It turns a little and then the lines blow off spraying freon and oil all over my face. Scarred the crap out of me. So after finding a bolt that is a little longer than the old one the lines are reattached. So I guess the new ac problem will be addressed next spring. What a day.