Anyone here have a 95 or 94 CPI Vortec Intake Manifold laying around?
#1
Anyone here have a 95 or 94 CPI Vortec Intake Manifold laying around?
Hi all,
Does anyone here have a 1994 or 1995 CPI Vortec "W" vin Lower Intake Manifold laying around? or currently off there engine? i need to know if there are rear coolant passages on either side near the back of the intake by the distributor hole? or if there is nothing there but solid aluminum?
thanks
Does anyone here have a 1994 or 1995 CPI Vortec "W" vin Lower Intake Manifold laying around? or currently off there engine? i need to know if there are rear coolant passages on either side near the back of the intake by the distributor hole? or if there is nothing there but solid aluminum?
thanks
#3
thanks
#5
Didn't we already go through this...? You still haven't made the decision...??
Go with what is suggested for your truck. The ones that are blocked off could lead to corrosion of the intake manifold at that location if there is any seepage which would just sit there stagnant.
In the end, it's your truck. If you think you'll get some more peace of mind with the gaksets meant for a different engine, then by all means, go for it.
Go with what is suggested for your truck. The ones that are blocked off could lead to corrosion of the intake manifold at that location if there is any seepage which would just sit there stagnant.
In the end, it's your truck. If you think you'll get some more peace of mind with the gaksets meant for a different engine, then by all means, go for it.
#6
yes we talked about the 2 different gaskets but i did not pull my enigine apart yet to look in it because the weather has been bad everytime i attempt to do it. and now im getting close to the return date so i have to return a set so i dont get stuck with 2 sets. thats why im asking for someone who has an intake off there truck for now.
#7
i'll ask my younger brother. he's currently putting a chromed CPI on his '83 Dime (to replace the factory plain aluminum one). he's coming up to my place this afternoon, so i'll get back to you shortly.
#8
ok thanks so much. can you look at both sides of the intake for any rear coolant ports? just curious, what is an 83 Dime?
#9
as for the "Dime" it's know as the S10 p/u. here's a pic of my brother's that i mentioned (the black one on the right) and a "satretched" '85 that me & my brother were building for a friend.
Thread
Thread Starter
Forum
Replies
Last Post
ClueMeIn1989
1st Generation S-series (1983-1994) Tech
7
06-15-2009 05:21 PM
95Blazer4x4
Engine & Transmission
4
02-08-2008 03:09 AM