what have you gotten done on your blazer today?
So I changed my upstream o2 sensors this morning
Looked like they have never been changed then I decided to look at my heater fan plug cause it had issues sometimes and I found the issue
so turns out a trip to the junkyard is in order to get a plug and fan
Looked like they have never been changed then I decided to look at my heater fan plug cause it had issues sometimes and I found the issue
so turns out a trip to the junkyard is in order to get a plug and fan
Installed new headliner and overhead console from a 98 blazer into my 96 jimmy and replace both outside mirrors also from a 1998 blazer. Gathering parts now to do a front end blazer conversion.....blacked out of course
pulled rear bumper off, and wew i do not like what i see.
I also installed a new radiator since the old one had a massive hole in it. Is there any procedure for the Oil cooler(s) for the Transmission and engine? bleeding air or anything, or just start it right up, bleed coolant, and then add fluids as necessary
I also installed a new radiator since the old one had a massive hole in it. Is there any procedure for the Oil cooler(s) for the Transmission and engine? bleeding air or anything, or just start it right up, bleed coolant, and then add fluids as necessary
Last edited by Mods; 02-13-2020 at 08:48 AM.
makes me sad too, thats the OE bumper, it even has the original antitheft etching sticker on it. right now my trucks sitting with a tarp wrapped around the crashbar and frame ends with everything soaked in stabil oil. i found even more rust on the running board endcap supports, and they're so damn seized in there that i cant remove them, the studs are spinning in the plastic.