No speaker box for me!

 

Now I get it looked further back on your build thread

 

Only a couple pages lol!

 

Hey rexmburns, when you bedlined your bumbers and grille, did you use any adhesion promoters?

 

the third picture cracks me up... its like the jeep just rolled into some one else territory and you guys are all there in your blazers. just to me i see the jeep driver thinking, just back out slowly, dont make any noise. lol.

 

Being new to the forum and these trucks I'm learning a lot. I got an 1989 GMC Jimmy S-15 4x4 for what I thought was a smoke-in deal of 800 bucks. WRONG !! I have done all the standard stuff, tune up, oil change, heater core, head light, the list goes on for the little stuff. I have found that you can't keep fluids in the truck. Oil, ATF, coolant, it all wont's out. I've replaced valve cover gaskets, oil sender, rear main seal, and intake gaskets on standby. The trans was leaking out of the front pump seal. Went to replace, and found that the torque converter bushing, torque converter, and flex plate were messed up. In it this far, rebuilt the trans. Tomorrow I'm changing out the motor mounts and the oil pan. I have found that motor mounts are important to keep the oil pan off the front dif. I have had this little Blazer for 1 month, my question is when does it stop, when can you just drive the thing ?....lol

 

HAHA I thought the same thing but my thought was Little Red Riding Hood and the three Black Wolves lol!

 

Today, Started the truck in the AM for my girlfriend, and am hibernating, because its too damn cold out.

 

drove it off trailer

 

tore down engine, getting ready for powder coating.